You will find the suitable anti-glare screen system for each protective device

Main Components – Square tube holding device, square tube, vane holding device, plastic vanes.

Square Tube Holding Device – The most varied square tube holding devices are fixed on to the corresponding base (usually on safety barriers). The square tube holding device can even adjust longitudinal differences of the base.

Square Tube – The square tube, a hot-galvanized square tube sized 45 x 45 x 2 mm, 3.960 mm long, is clamped on to the square tube holding device with only two screws.

Vane Holding Device – The vane holding device is the connecting piece between the square tube and the plastic vane. This holding device is clamped on to the square tube with a screw and it can also be displaced longitudinally.

blend aw 01
blend aw 02
blend aw 03

Plastic Vanes – The plastic vanes are made of highly molecular low-pressure polyethylene (PE-HD-HM) and are manufactured as an oval-shaped hollow body which is closed at the top. The vanes are green, dyed throughout (special colours available) with an absolutely smooth surface. The plastic vanes are fixed on to the vane holding device with four screws. These vanes are spread out at the bottom. This prevents sickle-shaped distortion of the vanes when sunlight only affects one side of the vane.

Vane Intervals – The vane intervals can be adjusted at any time if vanes with a fixed angle have been installed. For example, the vane interval can be shortened in curves of the road and extended on straight road sections.

Screws and Washers – All connecting components are hot-galvanized and can be supplied in V 2 A- or V 4 A-design upon request.

Special Designs

  • Individual heights of the vanes from 300 mm to 1.200 mm can be supplied at any time. If an order is placed for an anti-glare screen system that is higher than 1.200 mm, then several square tubes can be mounted with the vanes arranged over each other towards the top and the bottom.
  • Vane Adjustment: Rotatable designs (up to an angle of 180°) are available; displaceable vane holding devices with inclined vanes can also be supplied in any desired angle.